Plot No-C1-1031-9, GIDC Estate, Panoli, Ankleshwar, Gujarat - 393002. India
Telephone Mobile: 91-7506449333; e-mail: info@crystalclearproducts.orgManganese Bisglycinate ---- Manganese Borogluconate ---- Manganese Chloride ---- Manganese Gluconate ---- Manganese Glycerophosphate ---- Manganese Picolinate ---- Manganese Pidolate ---- Manganese Sulfate ---- Selenious Acid ---- L-selenomitheonine ---- Selenium Glycinate ---- Selenium Metal ---- Stannous Chloride Dihydrate ---- Stannous Fluoride ---- Zinc Acetate ---- Zinc Aspartate ---- Zinc Chloride ---- Zinc Citrate ---- Zinc Gluconate ---- Zinc Glycerophosphate ---- Zinc Glycinate ---- Zinc Lactate ---- Zinc Malate ---- Zinc Oxide ---- Zinc Peroxide ---- Zinc Picolinate ---- Zinc Pidolate ---- Zinc Stearate ---- Zinc Sufate ---- Zinc Undecenoate
Selenium Metal or Metallic Selenium Powder Pellets Shots Granules SDS MSDS of Manufacturers & Exporters
Selenium Metal or Metallic Selenium Powder Pellets Shots Granules CAS Number 7782-49-2Selenium Powder, Granules, Shots & Pellets SDS, Safety Data Sheet
MSDS Sheet, Material Safety Data Sheet 27-July-22Section 1. Product Information
Product Name & Other Names: Selenium Powder, Granules, Shots & Pellets
CAS No.: 7782-49-2
EINECS EC Number: 231-957-4
Chemical Formula: Se
Molecular Weight: 78.96
Relevant uses and uses advised against (if any): Industrial Manufacturing.
Suppliers: As per letterhead.Section 2: Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008Acute toxicity, Oral (Category 3), H301
Acute toxicity, Inhalation (Category 3), H331
Specific target organ toxicity - repeated exposure (Category 2), H373Labelling according to GHS & Regulation (EC) No 1272/2008
GHS Label Elements
Health HazardGHS Label Elements
ToxicSignal Words: Danger
Hazard statements:
H301 Toxic if swallowed.
H331 Toxic if inhaled.
H373 May cause damage to organs through prolonged or repeated exposure.Precautionary statements:
P260: Do not breathe dust/fume/gas/mist/vapors/spray.
P264: Wash --- thoroughly after handling.
P270: Do not eat, drink or smoke when using this product.
P271: Use only outdoors or in a well-ventilated area.
P273: Avoid release to the environment.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P314: Get medical advice/attention if you feel unwell.
P330: Rinse mouth.
P301+310: IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician.
P304+340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.Classification according to EU Directives 67/548/EEC or 1999/45/EC:
Hazard Symbols:
T = Toxic
Risk Phrases:
R23/25 = Toxic by inhalation and if swallowed.
R48 Danger of serious damage to health by prolonged exposure.Section 3: Composition and Information on Ingredients
Product Name & Other Names: Selenium Powder, Granules, Shots & Pellets
CAS No.: 7782-49-2
EINECS EC Number: 231-957-4Section 4. First Aid & Procedure
Always get medical attention after the first aid is over.
Ingestion: Induce vomiting immediately as directed by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention.
Skin: Immediately flush skin with plenty of water for at least 15 minutes. Remove and wash contaminated clothing and shoes before reuse. Get medical attention if irritation develops.
Eyes: Immediately flush eyes with plenty of water for 15 minutes, occasionally lifting upper and lower eyelids. Hold eyelids apart during irrigation. Get medical attention.
Inhalation: Remove person to fresh air. If breathing is difficult, give oxygen. If not breathing administer artificial respiration. Get medical attention.Section 5. Fire Fighting Measures
Flash Point: N/A
Extinguishing Medium: Water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Fire Fighting Instructions: Use suitable protective equipment for surrounding fire.
Extinguishing Media Not recommended: Avoid using solid water jet as it may scatter the fire.
Special Information: In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode. At high temperatures under fire conditions, it may produce toxic or irritating fumes. Fire-extinguishing work is done from the windward and the suitable fire-extinguishing method according to the surrounding situation is used.Section 6. Spills and Disposals
Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.). Do not approach facing the wind.
Environmental precautions: Do not let the product enter drains, soil, or water sources.
Methods and materials used for containment cleanup procedures and Storage: Do not inhale vapors, mist, or gas. Avoid dust formation. Contain spilled material. Cover with an inert, non-combustible absorbent material, (e.g., sand, earth, diatomaceous earth, vermiculite). Use a shovel to put the material into a convenient waste disposal container.Section 7. Handling and Storage
Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Avoid prolonged or repeated exposure. Ensure proper ventilation. In case of insufficient ventilation, wear suitable respiratory equipment. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.).
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like strong oxidizing agents.Section 8. Exposure Controls & Personal Protection
Exposure Limits for Selenious acid:
OSHA PEL: 0.2 mg/m3.
ACGIH TLV: 0.2 mg/m3 (TWA).
Engineering Controls: Use adequate exhaust ventilation to keep airborne concentrations below the allowable exposure limit.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator may be worn.
Skin Protection: Wear protective gloves and clean body-covering clothing.
Eye Protection: Use chemical safety goggles and/or full-face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice. Wash hands after handling.Section 9. Physical & Chemical Data
Appearance: Gray powder granules, shots, and pellets.
Odor: Not available.
Odor threshold: Not available.
pH: Not available.
Relative density: around 4.8
Melting Point: 217C
Initial boiling point and boiling range: 685C literature.
Flash point: Not available.
Auto-ignition temperature: No information found.
Decomposition temperature: No information found.
Upper/lower flammability or explosive limits: No information found.
Vapor pressure: No information found.
Vapor density: No information found.
Evaporation rate: No information found.
Flammability (solid, gas): No information found.
Partition coefficient: n-octanol/water: No information found.
Solubility: Insoluble in water
Viscosity: No information found.
Chemical Formula: Se
Molecular Weight: 78.96Section 10. Stability and Reactivity
Chemical Stability: Stable under normal temperatures and pressures.
Incompatibility (Materials to Avoid): Acids, Strong oxidizing agents, Fluorine, oxygen, Metals.
Conditions to Avoid: Incompatible materials, exposure to moist air or water, excessive heat.
Hazardous Decomposition Products: selenium Oxide and fumes.
Hazardous Polymerization: Will not occur.Section 11. Toxicological Information
Toxicity to Animals:
LD50 Oral = 6700 mg/kg ( Rat )
LC50 Inhalation = >5.67 mg/l (Rat) 4hr.
Carcinogenicity: Not listed as a suspected/confirmed carcinogen by ACGIH, IARC, NTP, SHA.
Teratogenic Effects: No information found.
Mutagenic Effects: No information found.
Developmental Toxicity: No information found.
Reproductive Effects: No information found.
Specific target organ toxicity: repeated exposure: May cause damage to organs through prolonged or repeated exposure.Section 12. Ecological Information
Ecotoxicity: May be toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
Results of PBT and vPvB Assessment: No information found.
Persistence and Degradability: No information found.
Mobility: No information found.
Bioaccumulation/ Accumulation: No information found.
Results of PBT and vPvB assessment: No information found.Section 13. Disposal Suggestions
Dispose of in accordance with all applicable local, state, and federal regulations at an approved waste disposal facility.
Section 14. Transport and Label Information
DOT USA, TDG Canada & ADR/RID Europe:
UN-No UN3283
Proper Shipping Name SELENIUM COMPOUND, N.O.S
Proper technical name: Selenium
Hazard Class 6.1
Packing Group III
IMDG/IMO
UN-No UN3283
Proper Shipping Name SELENIUM COMPOUND, N.O.S
Hazard Class 6.1
Packing Group III
IATA:
UN-No UN3283
Proper Shipping Name SELENIUM COMPOUND, N.O.S
Hazard Class 6.1
Packing Group IIISection 15. Regulatory Information
USA:
California Proposition 65: Not listed.
SARA 311/312: See section 2.Section 16. Other Information
Disclaimer:
**************************
Our company provides this MSDS sheet in good faith but makes no representation as to its comprehensiveness or accuracy. This SDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. The above information has been compiled from various sources and has the possibility of discrepancy and being out-dated information. Individuals receiving the information must exercise their independent judgment and do further search in determining its appropriateness for a particular purpose. In no case shall our company be liable to loss or damages by the product user.
**************************Crystal Clear Products and the group companies are manufacturing chemicals since several decades. We have automatic vacuum operated titanium evaporators and SS316 equipments to produce top grade of chemical products. We have toll manufacturers and representatives in China, UAE, Europe, Canada & USA and agents & customers in all countries like USA, Canada, Europe, UAE, South Africa, Tanzania, Kenya, Egypt, Nigeria, Uganda, Turkey, Mexico, Brazil, Chile, Argentina, Bangkok Thailand, Kaula Lumpur Malaysia, Dubai UAE etc. & sales representative in Chicago, Houston New York & Los Angeles, USA. Associated units are FDA-GMP certified, Halal and/or Kosher certified, REACH registered, ISO-9001, ISO-22000 HACCP certified, Crisil Rated.
Contact Selenium Metal or Metallic Selenium Powder Pellets Shots Granules IP BP Ph Eur EP JP USP NF ACS Analytical Reagent FCC Food Grade manufacturers exporters at:
Crystal Clear Products
Plot No-C1-1031-9, GIDC Estate, Panoli, Ankleshwar, Gujarat - 393002. India
Telephone Mobile: 91-7506449333; e-mail: info@crystalclearproducts.orge-mail: info@crystalclearproducts.org
Manufacturers, Suppliers of IP BP Ph Eur EP JP USP NF FCC Food, ACS Reagent GMP Grades of Chemicals like Selenium Metal or Metallic Selenium Powder Pellets Shots Granules